Tesla TI4100 GPU-24 Manual do Utilizador

!"#$%&'(#)*"'$%+,!"#$%& '()*#+,-"#& '(./012&3"(+",45-(+&6$7)/8"9&3%#+$&

CHAPTER 3OPERATING LIMITS AND RESTRICTIONSSECTION I. GENERAL3-1. PURPOSEChapter 3 includes all important operating limits and restrictionsthat must b

3-4. 208-240 VAC CHARGER AND AC TO DC CONVERTER LIMITSThe unit is designed with a single point AC receptacle for externalpower to operate both the in

WARNING********SHOCK HAZARD POTENTIAL*********Failure to use proper grounding can cause a potential shock hazard!In different countries, the 240 VAC 5

3-8. CONTINUOUS OUTPUT RATE, 28.5 VDC CONSTANT OUTPUT100 amp hours (with AC power connected)NOTEIf current demand exceeds 100 amps, converter output

CAUTIONUnit may be damaged if operated when unit’s cold or heat soaked tem-perature exceed the specified limit. If unit is operated when coldor heat

WARNING********SHOCK HAZARD POTENTIAL*********Severe injury, or Death, from electrical shock is possible when per-sonnel and/or Turbo Start 4100 are w

CAUTIONUnit damage may occur if inlet and outlet vent ports are obstructedand/or cooling air flow is restricted.3-13. UNIT OPERATION DURING AIRCRAFT

CHAPTER 4OPERATING PROCEDURESSECTION I. UNIT OPERATION4-1. GENERALCorrect operation of the TI4100GPU-24 (Turbo Start 4100) includesboth pre-use and

SECTION II. OPERATING PROCEDURES4-4. OPERATING PROCEDURESThis section deals with normal procedures, and includes all stepsnecessary to ensure safe an

CAUTIONREMEMBER, when the AC line cord is plugged in, the unit must beplaced in the horizontal position to allow the cooling fan to operateproperly!U

WARNING*******SHOCK HAZARD POTENTIAL*******IMPROPER USE/FAILURE TO FOLLOW INSTRUCTIONS IN OPERATORS MANUAL CAN RE-SULT IN UNIT FAILURE AND/OR POSSIBLE

4-7. 24 VDC GROUND POWER (WITH 208/240 VAC POWER) SYSTEM HIGH POWER DE-MAND (101 amps and above) OR ENGINE STARTING.1. TRANSPORT UNIT - The Turbo

4-8 28.5 VDC GROUND POWER (WITH 208/240 VAC POWER) SYSTEM LOW POWERDEMAND (100 amps or less).1. TRANSPORT UNIT - The Turbo Start 4100 is easily tr

CAUTIONUnit may overheat if cooling fan fails.Do not operate if cooling fan fails.2. CHECK FOR FULL CHARGE INDICATION - After 30 minutes, LED charge

SECTION III.FUNCTIONAL CHECK PROCEDURES4-10. FUNCTIONAL CHECK PROCEDURESThis section deals with normal functional check procedures, and in-cludes all

NOTEUnder a full charge, the last green LED bar may blink. This does notindicate a malfunction. A non-blinking lighted green bar or a blink-ing green

CHAPTER 5PERFORMANCE DATASECTION 1. INTRODUCTION5-1. PURPOSEThis chapter provides performance data for the TI4100GPU-24 (TurboStart 4100). Continual

SECTION IIDATA CRITERIA5-3 DATA BASISThe type of data used is indicated at the bottom of each performancechart under DATA BASIS. The applicable repo

5-3FIGURE 5-1

FIGURE 5-25-4TI41000GPU-24 OUTPUT VOLTAGEOUTPUT VOLTAGEMINUTES23 AMP CONSTANT CURRENT LOAD24201612840010 2030405060

FIGURE 5-35-500150300450600750900105015001350120051015202530************************************************************(+25 C Temp)(-29 C Temp)Ca

TABLE OF CONTENTSTITLE PageCHAPTER 1 INTRODUCTION 1-1CHAPTER 2 UNIT DESCRIPTION AND OPERATION 2-1Section I Unit 2-1Section II Description 2-2CHAPTER 3

CHAPTER 6CARE AND MAINTENANCESECTION I. UNIT CARE6-1. GENERAL Although the TI4100GPU-24 (Turbo Start 4100) has been ruggedizedand made weather resi

SECTION II.MAINTENANCE6-3. MAINTENANCE OF UNIT - The Turbo Start 4100 is a maintenance-free unit, no repairs are authorized. Warranty will be void i

Chapter 7Push To Test ModificationGeneral Information And Operation7-1. GeneralTHIS MODIFICATION HAS BECOME STANDARD EQUIPMENT FOR EACH OF OURUNITS.

Chapter 8ON/OFF SWITCHGeneral Information And Operation7-1. GeneralThe TI4100GPU-24 comes equipped with an On/Off switch on the faceplate, This switc

PARAGRAPH INDEX208-240 VAC Charger and AC to DC Converter Limits, 3-424 VDC Ground Power (NO 208-240 VAC Power Supply) Engine Starting orDC system P

PARAGRAPH INDEXIndex, 1-4Maintenance of Unit, 6-3Maximum Output Current, Figure 5-3On/Off Switch General, 8-1On/Off Switch Operation, 8-2One (1) Ho

CHAPTER 1INTRODUCTION1-1. GENERALThese instructions are for use by the owner/operator. They apply tohandling and operation of the TI4100GPU-24 (Tur

1-4. INDEXThe index lists, in alphabetical order, every titled paragraph andfigure contained in this manual.1-5. ABBREVIATIONS AND SYMBOLSAbbreviati

1-6. FORMS AND RECORDSNONE REQUIRED.1-7. USE OF WORDS SHALL, SHOULD, AND MAY.Within this technical manual the word “shall” is used to indicate amand

CHAPTER 2UNIT DESCRIPTION AND OPERATIONSECTION I. UNIT2-1. GENERALThe TI4100GPU-24 (Turbo Start 4100) (Figure 2-1 and 2-2) is a compact, por-table an

SECTION II DESCRIPTION2.2. GENERAL SPECIFICATIONSWEIGHTUNIT: 100 lbs (50.39 Kg)DC POWER CABLE: 8.5 lbs (3.86 Kg)AC POWER CORD: 0.4 lbs (0.18 Kg)INPU

2-3UNIT DISCRIPTION AND DEMENTIONS